Fixed the issue when setting a blank setting value, BCU no longer stops working.Improves the BIOS update installation process.Fixed an issue where the BIOS Configuration Utility clears the current BIOS administrator password when the incorrect BIOS password is input.Updated with new HPQPwd.exe and HPQPwd64.exe version 1.0.27.1.BCU now errors out if missing the setting's value and reports "invalid setting value" Fixed BCU crash issue where the BCU config file contains incomplete settings value.Added support for single value get (/getvalue:"setting name") and save it to a file.Provides a warning message when incomplete settings or values for settings are not detected.BCU.exe /get:repset.txt /logpath:"c:\BCUlogs\mylog.txt") Provides the ability to specify the location to save log files using the /logpath parameter.Fixes an issue where the BIOS Configuration Utility does no replace the older BCU version when an update is run.Note: BCU will ignore to add the device if it is not in BIOS API. For example: If an additional device added to the system (e.g USB Hard drive) after BCU read, BCU will automatically add this entry under toīCU config file. Enhance to automatically add system's boot order value in the BIOS config file.Fiexes an issue where adding "Disabled" to a boot option doesn't update correctly in F10 setting. ![]() Messaging added to notify the user that a system reboot is necessary for updatted settings to take effect.Fixes an issue where the boot order would be set incorrectly on some systems.Fixes where BCU can set successfully when set the MPM counter to a non-integer value (eg.Fixes where BIOS returns a non-zero (fail) result and BCU is incorrectly reporting success.Fixes where using /addauthstr on a full repset file containing read only settings causes an error to occur.Use /setvalue command with a provided password file when BIOS password is set on system.Adds PFX files with passwords on private key.*Does not support XP systems that have set the BIOS setup password. ROMBO software included an interleaving utility for user-generated DOS source files.This package provides the HP BIOS Configuration Utility (BCU) for supported notebook, desktop, and workstation models that are running a supported operating system. Singles are programmed byte sequential, but pairs are programmed even bytes in first ROM and odd bytes in second ROM. ![]() Portable Plus reads software drawer ROMs as 16-bits wide, whether the ROMs are singles or pairs. This allows ROMBO to select the upper and lower 64KB blocks during programming. To program on the ROMBO, two jumpers are removed from the module, and a 5-pin cable connects the jumper pins to a personality module on the ROMBO. 27C1024 (128KB) EPROMS are 32-pin packages, so the Personalized Software custom EPROM module mounts a 32-pin PLCC package on a PCB adapter to 28 pins. I will also try to duplicate some 128KB ROMs onto the custom 128KB EPROMS. I bought a generic USB programmer that I will use to duplicate some 27C512 (64KB) EPROMs. ![]() I contacted Hal Goldstein, but he was unable to find a copy in his archives. I have the manual and some custom 128KB EPROM modules, but I lost the software. I own a ROMBO EPROM programmer from Personalized Software.
0 Comments
Leave a Reply. |